I usually create my wearable art on a "flat" background and can normally avoid having to insert darts. I saw the jacket made up in Cherrywood's sueded cotton at their booth at a quilt show and fell in love with it, thinking that it would be fast with pre-cut strips (anything to avoid lots of cutting!) So I bought the pattern (which luckily included Cherrywood's suggestions for making it), a Cherry Roll, and yardage for the lining and binding to make the jacket. I went to Downie's booth to try on her finished samples and determined what size I needed.
Once I opened the pattern, I realised that it had princess seams.......... but thought that that would be fine. I made a muslin, and in accordance with Cherrywood's suggestion did not stiffen it with fusible interfacing. The muslin fit, so I proceeded to work on the jacket. Instead of using uneven size strips which the pattern called for I used even strips, pinned and straight stitched them in place as instructed, leaving the area where the yoke and body intersect to be covered at the end I then free motion zigzagging over the joins using 40wt variegated cotton thread. I started with the sleeves which were flat. They went fine. I then made the back, which was slight shaped and that worked. I then started one of the front sides, and found it quite difficult to lay straight-cut strips over the curves created by the princess seams in the bust area. I soldiered on, free motion quilting them, then stopped where the gap was. It measured over 3" in places. At that point, I knew that I needed a creative solution, as 2 1/2" strips were not going to do the job. I consulted other local sewers for their advice, but no one had seen anything like this.
I finally took the front piece with me to Houston for help. (I even carried it in my hand luggage to ensure that it did not get lost.) As soon as Preview Night opened I made a bee-line for Cherrywood's booth which was customer-free. I talked to Karla who referred me to the person who had made their sample. I will interpose that she is very petite. After talking to her, I determined that the only thing I could do was to buy another 1/2 yard of a coordinating fabric (the color I had wanted to use is only made for the cherry rolls) and cut wider strips, possibly pleating them to make them fit over the curve. I ended up cutting a fairly wide strip for each side of the front to go over the curve.
Once all the quilting was done (the top, muslin and lining are quilted together) I realised that the garment had shrunk up a bit. So I panicked all through dinner on Saturday night until I could get a sleeve sewn to make sure it fitted. Luckily I have been working out hard, and the bicep area, which is usually my problem area, fit. It was also challenging matching the shoulder and under arm seams, as due to the overlapping strips, there are ten thicknesses of fabric at some of the seams. After reading Cherrywood's comments about having to pleat the straight-cut neck binding, I decided to cut mine on the bias, which made it much easier going around the neckline curves. By now I had used up two 500yard spools of 40 weight variegated cotton. Having had a quiet New Year weekend, I thought I could finish the jacket on Sunday night. I was sewing away and a needle broke. I was about to change the needle when everything went dark except for my machines which are on UPS's. Yes.......the electricity had gone off. End of sewing for the night. Then on Tuesday, when I was ready to sew on the last piece of binding (the binding was also free motion zig-zagged on) I noticed that my bobbin had less than 12% thread left on it, and there was virtually no thread on the spool either. A 7:30pm call to my local Bernina dealer Sew Vac Ltd found them open, with two spools of the thread I needed, so I dashed up there and got the thread before closing time to finish the jacket. The button, which I purchased at Laura Murray's booth at Houston is by Crone Art. Now it is pressed and ready to wear.
